LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2017 >> Spark LT, Automatic CVT Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 51 (Folding Top) >> Repair Instructions >> Folding Top Latch Sensor Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2019 Buick Cascada, 2018 Buick Cascada, and 2017 Buick Cascada. However, it is still accessible from the selected car via links, so may be relevant.
  1. GM3405261

    Install the NEW sensor (2) to the folding top. Use new rivet (3).

  2. Connect the 2 sensor wires (4) to the wiring harness (1). Refer to Wiring Repairs .
  3. GM3405260

    Insulate the wiring harness. Use electrical tape.

  4. Connect the battery negative cable. Refer to Battery Negative Cable Disconnection and Connection .
  5. Install the folding top front panel. Refer to Folding Top Front Panel Replacement .
scientia non olet · About LEMON Manuals