Installation Procedure
WARNING: This page is about a different car, the 2019 Buick Cascada, 2018 Buick Cascada, and 2017 Buick Cascada. However, it is still accessible from the selected car via links, so may be relevant.
- Install NEW sealing rings to hydraulic cylinder.
- Install the NEW hydraulic hose to the hydraulic cylinder and install the fixation clamps.
- For the folding top front cylinder refer to Folding Top Cylinder Replacement - Front .
- For the folding top rear cylinder refer to Folding Top Cylinder Replacement - Rear .
Click in the NEW hydraulic hose to the retainers (1).
Insert the NEW folding top hydraulic hose to the hydraulic pump connector plate (2).
- Click in the secure ring (1) to the NEW hydraulic cylinder hose.
Install the connector plate to the hydraulic pump (1).
- Install the 3 connector plate bolts (2) and tighten to 10 N.m (89 lb in)
- Check the correct level of the hydraulic oil, install the hydraulic pump and the trunk inner covers. Refer to Folding Top Pump Replacement
CAUTION:
Refer to Fastener Caution .