LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2017 >> Spark LT, Automatic CVT Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 51 (Folding Top) >> Diagnostic Information and Procedures >> DTC B36B5 and B36B6 >> Circuit/System Verification

Circuit/System Verification

WARNING: This page is about a different car, the 2019 Buick Cascada, 2018 Buick Cascada, and 2017 Buick Cascada. However, it is still accessible from the selected car via links, so may be relevant.
  1. Ignition ON
  2. Verify the scan tool B251 Folding Top Down Position Sensor parameter changes between Active and Inactive when closing and opening folding top.
    • If parameter does not change between Active and Inactive 

      Refer to the Circuit/System Testing - Diagnostic A

    • Go to next step: If parameters change between Active and Inactive 
  3. Verify the scan tool B252 Folding Top Up Position Sensor parameter changes between Active and Inactive when closing and opening folding top.
    • If parameter does not change between Active and Inactive 

      Refer to the Circuit/System Testing - Diagnostic B

    • Go to next step: If parameters change between Active and Inactive 
  4. All OK.
scientia non olet · About LEMON Manuals