LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2017 >> Spark LT, Automatic CVT Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 49 (Lighting System - Repair Instructions) >> Repair Instructions >> Headlamp Leveling Rear Suspension Height Sensor Exciter Plate Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2019 Buick Cascada, 2018 Buick Cascada, and 2017 Buick Cascada. However, it is still accessible from the selected car via links, so may be relevant.
  1. GM2372548

    Install the headlamp leveling rear suspension height sensor exciter plate (1).

    2. CAUTION:

    Refer to Fastener Caution .

    NOTE:

    The headlamp leveling rear suspension height sensor exciter plate (1) needs to be pushed forward (arrow) during assembly and fastening of the bolt.

  2. Install the headlamp leveling rear suspension height sensor exciter plate bolt and tighten to 9 N.m (80 lb in).
  3. Lower the vehicle.
  4. After repairs, refer to Control Module References for programming and set up procedures.
  5. Aim the headlamps after installation. Refer to Headlamp Aiming .
scientia non olet · About LEMON Manuals