Seat Belt Latch Stop Installation
WARNING: This page is about a different car, the 2019 Buick Cascada, 2018 Buick Cascada, and 2017 Buick Cascada. However, it is still accessible from the selected car via links, so may be relevant.
| Callout |
Component Name |
|
Preliminary Procedure
- Locate the hole in the seat belt webbing where the original seat belt stop button was located.
- If the original hole in the seat belt webbing is not visible, perform the following:
- If either the right or left stop button is missing use the opposing seat belt as a reference.
- With the opposing seat belt fully stowed, measure the distance between the seat belt lower anchor and the stop button.
- Using the measurement obtained above, measure and mark the location of the missing stop button on the center of the seat belt webbing.
- Ensure the seat belt latch plate is located above the mark or original hole.
|
| 1 |
Seat Belt Latch Stop Procedure
- Work the male half of the stop button through the hole in the webbing or at the marked location.
- Align the female half of the stop button with the male half of the stop button.
- Snap the two halves together.
- Trim off any access of the male half of the stop button flush with the female half of the stop button.
TIP:
Ensure the male half of the stop button is facing forward in the vehicle in order to ensure the stop button will not snag customers clothing. |