Driver or Passenger Seat Outer Adjuster Finish Cover Replacement

WARNING: This page is about a different car, the 2019 Buick Cascada, 2018 Buick Cascada, and 2017 Buick Cascada. However, it is still accessible from the selected car via links, so may be relevant.

Callout	Component Name
1	Driver or Passenger Seat Outer Adjuster Finish Cover CAUTION: Note the correct routing of the electrical wiring. Failure to reinstall the wiring properly could result in damage to the wiring. NOTE: Re-installing the wiring harness to the cover requires an inspection of the wiring harness in all functional positions of the seat. Make sure that the white marker on the wiring harness is visible in front of the most forward cable retainer. Procedure Start removal of the cover on the rear side, unclip cover from seat belt retractor, then slightly pull cover outward. Push cover forward to remove it from seat belt retractor. Detach wiring harness from cover.

Callout

Component Name

Driver or Passenger Seat Outer Adjuster Finish Cover

CAUTION:

Note the correct routing of the electrical wiring. Failure to reinstall the wiring properly could result in damage to the wiring.

NOTE:

Re-installing the wiring harness to the cover requires an inspection of the wiring harness in all functional positions of the seat. Make sure that the white marker on the wiring harness is visible in front of the most forward cable retainer.

Procedure

Start removal of the cover on the rear side, unclip cover from seat belt retractor, then slightly pull cover outward. Push cover forward to remove it from seat belt retractor.
Detach wiring harness from cover.