LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2017 >> Spark LT, Automatic CVT Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 4 (Tires And Wheels) >> Diagnostic Information and Procedures >> Radial Tire Lead/Pull Correction

Radial Tire Lead/Pull Correction

WARNING: This page is about a different car, the 2019 Buick Cascada, 2018 Buick Cascada, and 2017 Buick Cascada. However, it is still accessible from the selected car via links, so may be relevant.
Step Action Yes No
DEFINITION: Lead/pull is the deviation of the vehicle from a straight path on a level road with no pressure on the steering wheel.
1 Did you perform the Vehicle Leads/Pull diagnostic table? Go to Step 2  Go to Vehicle Leads/Pulls
2 Road test the vehicle to verify the complaint. Select a smooth level surface to perform the test.
Does the condition exist?		 Go to Step 3  System OK
3
  1. Cross-switch the left front tire/wheel assembly with the left rear tire/wheel assembly. Refer to Tire and Wheel Removal and Installation .
  2. Road test the vehicle on a smooth level surface.
Does the vehicle still lead/pull?		 Go to Step 4  Go to Step 5 
4
  1. Cross-switch the right front tire/wheel assembly with the right rear tire/wheel assembly. Refer to Tire and Wheel Removal and Installation .
  2. Road test the vehicle on a smooth level surface.
Does the vehicle still lead/pull?		 Go to Wheel Alignment Measurement Go to Step 6 
5 Replace the left rear tire.
Is the repair complete?		 Go to Step 7  -
6 Replace the right rear tire.
Is the repair complete?		 Go to Step 7  -
7 Verify proper vehicle operation.
Does the original condition still exist?		 Go to Step 1  System OK
scientia non olet · About LEMON Manuals