LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2017 >> Spark LT, Automatic CVT Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 39 (Hydraulic Brake System) >> Repair Instructions >> Power Brake Booster Pump Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2019 Buick Cascada, 2018 Buick Cascada, and 2017 Buick Cascada. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the engine sight shield. Refer to Engine Sight Shield Replacement .
  2. Remove the engine control module from its bracket and reposition it without disconnecting any electrical connectors.
  3. Remove the engine wiring harness from the brackets as necessary.
  4. Remove the power brake booster vacuum pipe from the power brake booster vacuum pump. Refer to Power Brake Booster Vacuum Pipe Replacement .
  5. GM2949072

    Remove the engine wiring harness nut (2) and remove the engine wiring harness bracket (1).

  6. GM2949073

    Remove the power brake booster pump bolts (2) along with the stud (3).

  7. Remove the power brake booster pump (2).
  8. Remove and DISCARD the power brake booster pump gasket (1):
scientia non olet · About LEMON Manuals