LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2017 >> Spark LT, Automatic CVT Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 39 (Hydraulic Brake System) >> Repair Instructions >> Front Brake Hose Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2019 Buick Cascada, 2018 Buick Cascada, and 2017 Buick Cascada. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:

Refer to Brake Fluid Irritant Warning .

CAUTION:

Refer to Brake Fluid Effects on Paint and Electrical Components Caution .

  1. Remove the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation .
  2. Clean all dirt and foreign material from the brake hose ends and the brake pipe fitting.
  3. GM2027735

    Use a flare nut wrench on the brake pipe fitting (1) and a backup wrench on the brake hose (3) under the brake hose retainer (2) as shown.

  4. Cap or plug the brake pipe fitting end and the brake hose end to prevent fluid loss and contamination.
  5. GM2966370

    Remove the brake hose bolt (1) and remove and DISCARD the 2 brake hose gaskets (3).

  6. Remove the front brake hose (2) from the brake hose brackets.
scientia non olet · About LEMON Manuals