Installation Procedure
WARNING: This page is about a different car, the 2019 Buick Cascada, 2018 Buick Cascada, and 2017 Buick Cascada. However, it is still accessible from the selected car via links, so may be relevant.
- NOTE:
Remove the caps from the brake pipe fittings.
Clip the brake pressure modulator valve primary pipe (1) in the 3 - way clip (4).
- Install the brake pressure modulator valve primary pipe (1) to the brake pressure modulator valve (3). Only hand tightening.
- Install the brake pressure modulator valve primary pipe (1) to the master cylinder (2). Only hand tightening.
- Tighten the 2 brake pressure modulator valve primary pipe coupling nuts to 18 N.m (13 lb ft).
Position the surge tank (1).
- Install the clamp (2) to the surge tank (1) and the surge tank bracket (3).
- Connect the electrical connector (4) to the surge tank coolant fluid sensor (5).
- Install the battery tray. Refer to Battery Tray Replacement .
- Bleed the hydraulic brake system. Refer to Hydraulic Brake System Bleeding .
WARNING:
Make sure brake pipes are correctly connected to brake pressure modulator valve. If brake pipes are switched by mistake, wheel lockup will occur and personal injury may result. The only two ways this condition can be detected are by using a Scan Tool or by doing an Antilock stop.
CAUTION:
Refer to Fastener Caution .