Fastener Specifications
WARNING: This page is about a different car, the 2019 Buick Cascada, 2018 Buick Cascada, and 2017 Buick Cascada. However, it is still accessible from the selected car via links, so may be relevant.
Single Use Non-Threaded Fasteners/Components
|
NOTE:
All fasteners/components listed in this table MUST BE DISCARDED and replaced with NEW after removal. |
|---|
| Application |
| Front Side Door Trim Retainer |
Reusable Threaded Fastener Tightening Specifications
|
NOTE:
All fasteners listed in this table can be reused after removal. |
|
|---|---|
| Application | Specification |
| Metric (English) | |
| Body Side Front Lower Trim Panel Bolt | 1.6N.m (14 lb in) |
| Front Side Door Inside Handle Bolt | 1.6 N.m (14 lb in) |
| Front Side Door Pull Handle Bolt | 1.6 N.m (14 lb in) |
| Rear Compartment Lid Pull Handle Bolt | 2.5 N.m (22 lb in) |
| Roof Front Header Garnish Molding Nut | 8 N.m (71 lb in) |
| Sunshade Fastener | 2.5 N.m (22 lb in) |
| Sunshade Support Bolt | 2.5 N.m (22 lb in) |
| Quarter Upper Trim Panel Bolt | 1.6 N.m (14 lb in) |
| Quarter Window Trim Finish Panel Bolt | 2.5 N.m (22 lb in) |