LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2017 >> Spark LT, Automatic CVT Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 26 (Automatic Transmission - 6T45 (MH7) - Repair Instructions - On Vehicle) >> Repair Instructions - On Vehicle >> Range Selector Lever Cable Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2019 Buick Cascada, 2018 Buick Cascada, and 2017 Buick Cascada. However, it is still accessible from the selected car via links, so may be relevant.
  1. Set the park brake and chock the wheels.
  2. Remove the instrument panel lower center compartment. Refer to Instrument Panel Lower Center Compartment Replacement .
  3. Without disconnecting the electrical connector, remove the engine control module and hang aside. Refer to Engine Control Module Replacement .
  4. Verify that the transmission range selector lever is in park position.
  5. Verify that the transmission manual shift lever is in park position.
  6. GM2001179

    Disconnect the transmission range selector lever cable terminal (1) from the transmission manual shift lever pin.

  7. Press the locking tabs inward in order to release the transmission range selector lever cable (2) from the cable bracket.
  8. GM2917582

    Release the range selector cable adjuster clip (2).

  9. Press the locking tabs inwards (arrows) in order to release the transmission range selector lever cable (1).
  10. Remove the transmission range selector lever cable from the transmission control.
  11. GM2834260

    Remove the transmission range selector lever cable grommet (2) from the bulkhead (1).

  12. Remove the transmission range selector lever cable (3).
scientia non olet · About LEMON Manuals