LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2017 >> Spark LT, Automatic CVT Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 26 (Automatic Transmission - 6T45 (MH7) - Repair Instructions - On Vehicle) >> Repair Instructions - On Vehicle >> Range Selector Lever Cable Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2019 Buick Cascada, 2018 Buick Cascada, and 2017 Buick Cascada. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the transmission range selector lever cable.
  2. GM2834260

    Install the transmission range selector lever cable grommet (2) to the bulkhead (1).

  3. GM2917582

    Install the transmission range selector lever cable to the transmission control.

  4. Install the transmission range selector lever cable to the range selector adjuster clip (2).
  5. Press the locking tabs inward (arrows) and clip in the transmission range selector lever cable (1) to the transmission control.
  6. GM2001179
    WARNING:

    Hold the transmission range selector lever while removing or installing the lever retaining nut. Excessive torque on the manual shaft can damage the detent lever hub retainer which could allow the vehicle to roll when placed in the park position.

    Connect the transmission range selector lever cable terminal (1) to the transmission manual shift lever pin.

  7. Press the locking tabs inward and clip in the transmission range selector lever cable (2) to the cable bracket.
  8. Adjust the range selector cable. Refer to Range Selector Lever Cable Adjustment .
  9. Install the instrument panel lower center compartment liner. Refer to Instrument Panel Lower Center Compartment Replacement .
  10. Install the engine control module. Refer to Engine Control Module Replacement .
scientia non olet · About LEMON Manuals