LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2017 >> Spark LT, Automatic CVT Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 26 (Automatic Transmission - 6T45 (MH7) - Repair Instructions - On Vehicle) >> Repair Instructions - On Vehicle >> Range Selector Lever Cable Bracket Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2019 Buick Cascada, 2018 Buick Cascada, and 2017 Buick Cascada. However, it is still accessible from the selected car via links, so may be relevant.
  1. GM2190652

    Install the transmission range selector cable bracket (3).

    2. CAUTION:

    Refer to Fastener Caution .

  2. Install the transmission range selector cable bracket bolts (1, 2) and tighten to 22 N.m (16 lb ft).
  3. GM2001179

    Connect the range selector cable (2) to the range selector cable bracket.

  4. Connect the range selector cable end (1) to the range selector lever.
  5. Check the range selector cable adjustment. Refer to Range Selector Lever Cable Adjustment .
  6. Install the battery tray. Refer to Battery Tray Replacement .
scientia non olet · About LEMON Manuals