LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2017 >> Spark LT, Automatic CVT Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 26 (Automatic Transmission - 6T45 (MH7) - Repair Instructions - On Vehicle) >> Repair Instructions - On Vehicle >> Manual Shift Detent Lever with Shaft Position Switch Assembly Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2019 Buick Cascada, 2018 Buick Cascada, and 2017 Buick Cascada. However, it is still accessible from the selected car via links, so may be relevant.
  1. GM1998832

    Connect the actuator rod (3) to the detent lever assembly.

  2. Install the manual shaft detent (with shift position switch) lever assembly (4).
  3. Install the manual shaft (2).
  4. Install the NEW manual shaft detent lever hub pin (1) to height of 7.9 mm (0.38 in) (b).
    5. CAUTION:

    Use J 41229 to install the manual shaft pin at the correct height in order to properly secure the manual shaft. If you install the pin too deep, the case bore may crack.

  5. Install the NEW manual shift shaft pin (5) using DT-41229  pin installer. Use a NEW pin to ensure proper engagement with the case.
  6. Inspect pin installed height is within 7.2 - 8.2 mm (0.28 - 0.32 in) (a).
  7. Install the control valve body. Refer to Control Valve Body Replacement .
  8. After repairs, refer to Control Module References for programming and set up procedures.
scientia non olet · About LEMON Manuals