Front Wheel Drive Shaft Seal Replacement - Left Side
WARNING: This page is about a different car, the 2019 Buick Cascada, 2018 Buick Cascada, and 2017 Buick Cascada. However, it is still accessible from the selected car via links, so may be relevant.
| Callout |
Component Name |
|
Preliminary Procedures
- Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle
.
- Place a suitable container under the left front wheel drive shaft oil seal.
- Remove the left front wheel drive shaft. Refer to Front Wheel Drive Shaft Replacement - Left Side
.
|
| 1 |
Left Front Wheel Drive Shaft Oil Seal Procedure
- For seal removal use DT-7004
slide hammer with DT-586
seal remover.
- For seal installation use DT-8092
driver handle with DT-47790
seal installer.
- After the installation of the left front wheel drive shaft check the transmission fluid level. Refer to Transmission Fluid Drain and Fill .
Special Tools
- DT-586
Universal Seal Remover
- DT-7004
Slide Hammer
- DT-8092
Driver Handle
- DT-47790
Seal Installer
For equivalent regional tools, refer to Special Tools
. |