LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2017 >> Spark LT, Automatic CVT Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 26 (Automatic Transmission - 6T45 (MH7) - Repair Instructions - On Vehicle) >> Repair Instructions - On Vehicle >> Automatic Transmission Range Selector Lever Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2019 Buick Cascada, 2018 Buick Cascada, and 2017 Buick Cascada. However, it is still accessible from the selected car via links, so may be relevant.
  1. GM2001183
    WARNING:

    Hold the transmission range selector lever while removing or installing the lever retaining nut. Excessive torque on the manual shaft can damage the detent lever hub retainer which could allow the vehicle to roll when placed in the park position.

    Install the transmission range selector lever (2).

    2. CAUTION:

    Refer to Fastener Caution .

  2. Install the transmission range selector lever nut (1) and tighten to 30 N.m (22 lb ft).
  3. GM2001179

    Install the transmission range selector lever cable (2) to the cable bracket.

  4. Connect the transmission range selector lever cable terminal (1) to the transmission manual shift lever pin.
  5. Check the range selector cable adjustment. Refer to Range Selector Lever Cable Adjustment .
  6. Install the battery tray. Refer to Battery Tray Replacement .
scientia non olet · About LEMON Manuals