LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2017 >> Spark LT, Automatic CVT Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 24 (Wiring Systems And Power Management - Repair Instructions) >> Repair Instructions >> Yazaki Connectors (2-Way) >> Terminal Removal Procedure

Terminal Removal Procedure

WARNING: This page is about a different car, the 2019 Buick Cascada, 2018 Buick Cascada, and 2017 Buick Cascada. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the connector from the component.
  2. GM1454532

    Insert a small flat-blade tool in the slot below the front loaded terminal position assurance (TPA) and pry up.

  3. Remove the TPA by pulling it out of the connector.
  4. Push the wire side of the terminal that is being removed toward the connector and hold it in position.
  5. GM1454546

    Insert the J-38125-553 on a slight upward angle into the cavity below the terminal to be removed. Ensure that the pointed on the end of the tool is facing the bottom of the terminal and it stays in contact with the terminal until it stops on the plastic terminal retainer.

  6. GM1454553

    Gently pry the plastic terminal retainer down and carefully pull the terminal out of the connector. Always remember never use force when pulling a terminal out of a connector. If the terminal is difficult to remove, repeat the entire procedure.

  7. Repair the terminal by following the Repairing Connector Terminals (Terminated Lead Repair)  procedure.
  8. Insert the repaired terminal back into the cavity. Repeat the diagnostic procedure to verify the repair and reconnect the connector bodies.
scientia non olet · About LEMON Manuals