High Temperature Wiring Repairs
WARNING: This page is about a different car, the 2019 Buick Cascada, 2018 Buick Cascada, and 2017 Buick Cascada. However, it is still accessible from the selected car via links, so may be relevant.
Use the following procedures to perform high temperature wiring repairs:
- Center the high temperature SCT1 shrink tube over the DuraSeal splice sleeve.
- Using the heat torch, apply heat to the high temperature heat shrink tubing.
- Gradually move the heat from the center to the open end of the tubing:
- The tubing will shrink completely as the heat is moved along the insulation.
- A small amount of sealant will come out of the end of the tubing when sufficient shrinkage is achieved.
- Replace any reflective tape and clips that may have been removed during the repair.