LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2017 >> Spark LT, Automatic CVT Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 24 (Wiring Systems And Power Management - Repair Instructions) >> Repair Instructions >> Tyco/AMP Connectors (Door Module) >> Terminal Removal Procedure

Terminal Removal Procedure

WARNING: This page is about a different car, the 2019 Buick Cascada, 2018 Buick Cascada, and 2017 Buick Cascada. However, it is still accessible from the selected car via links, so may be relevant.
GM1709293

Side view of connector.

GM1709294

View of top of connector.

  1. Locate the assist lever and lock on the top of the connector.
  2. GM1709295

    While depressing the lock, pull the lever over and past the lock.

  3. GM1709296

    Disconnect the connector from the component.

  4. GM1709297

    Locate the dress cover locking tabs at the rear of the connector. Use a small flat-blade tool to release the locking tabs. Repeat this procedure for the other locking tab.

  5. GM1709298

    Once the locking tabs are unlocked, slide the inner connector out of the rear of the connector housing.

  6. GM1709299

    Use the J-38125-12A tool to release the terminals by pressing on the tang.

  7. While holding the removal tool in place, gently pull the wire out of the back of the connector. Always remember never use force when pulling a terminal out of a connector.
  8. Repair the terminal by following the Repairing Connector Terminals (Terminated Lead Repair)  procedure.
  9. Insert the repaired terminal back into the cavity. Repeat the diagnostic procedure to verify the repair and reconnect the connector bodies.
scientia non olet · About LEMON Manuals