LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2017 >> Spark LT, Automatic CVT Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 24 (Wiring Systems And Power Management - Repair Instructions) >> Repair Instructions >> Kostal Connectors (Transmission) >> Terminal Removal Procedure

Terminal Removal Procedure

WARNING: This page is about a different car, the 2019 Buick Cascada, 2018 Buick Cascada, and 2017 Buick Cascada. However, it is still accessible from the selected car via links, so may be relevant.
  1. GM1921876

    While depressing the lock, twist and remove the connector from the component.

  2. GM1921872

    Locate the terminal position assurance (TPA).

  3. GM1921873
    NOTE:

    The TPA cannot be removed from the connector while there are terminals present in the connector body.

    Use a small flat-blade tool to push the TPA until it bottoms out.

  4. GM1921843

    Use the J-38125-28 tool to release the terminals by inserting the tool into the terminal cavity as shown in the graphic.

  5. While holding the removal tool in place, gently pull the wire out of the back of the connector. Always remember never use force when pulling a terminal out of a connector.
  6. Repair the terminal by following the Repairing Connector Terminals (Terminated Lead Repair)  procedure.
scientia non olet · About LEMON Manuals