LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2017 >> Spark LT, Automatic CVT Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 24 (Wiring Systems And Power Management - Repair Instructions) >> Repair Instructions >> Kostal Connectors (Transmission) >> Terminal Insertion Procedure

Terminal Insertion Procedure

WARNING: This page is about a different car, the 2019 Buick Cascada, 2018 Buick Cascada, and 2017 Buick Cascada. However, it is still accessible from the selected car via links, so may be relevant.

After the terminal is replaced, perform the following procedure in order to insert the terminal.

  1. Slide the new terminal into the correct cavity at the back of the connector.
  2. Push the terminal into the connector until it locks into place. The new terminal should be even with the other terminals. Ensure that the terminal is locked in place by gently pulling on the wire.
  3. GM1921848

    Locate the TPA.

  4. GM1921849

    Use a small flat-blade tool to push the TPA until it bottoms out.

  5. GM1921872

    Ensure the TPA is fully seated. The TPA should be centered and flush with the connector body when viewed.

scientia non olet · About LEMON Manuals