LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2017 >> Spark LT, Automatic CVT Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 24 (Wiring Systems And Power Management - Repair Instructions) >> Repair Instructions >> Delphi Connectors (Push To Seat) >> Terminal Removal Procedure

Terminal Removal Procedure

WARNING: This page is about a different car, the 2019 Buick Cascada, 2018 Buick Cascada, and 2017 Buick Cascada. However, it is still accessible from the selected car via links, so may be relevant.

Follow the steps below in order to repair push to seat connectors.

  1. Remove the terminal position assurance (TPA) device, the connector position assurance (CPA) device, and/or the secondary lock.
  2. GM8802

    Separate the connector halves (1).

  3. GM8803

    Use the proper pick or removal tool (1) in order to release the terminal.

  4. Gently pull the cable and the terminal (2) out of the back of the connector.
  5. GM8804

    Re-form the locking device if you are going to reuse the terminal (1).

  6. Repair the terminal by following the Repairing Connector Terminals (Terminated Lead Repair)  procedure.
  7. Insert the repaired terminal back into the cavity. Repeat the diagnostic procedure to verify the repair and reconnect the connector bodies.
scientia non olet · About LEMON Manuals