LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2017 >> Spark LT, Automatic CVT Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 24 (Wiring Systems And Power Management - Repair Instructions) >> Repair Instructions >> Bosch Connectors (0.64) >> Terminal Removal Procedure

Terminal Removal Procedure

WARNING: This page is about a different car, the 2019 Buick Cascada, 2018 Buick Cascada, and 2017 Buick Cascada. However, it is still accessible from the selected car via links, so may be relevant.
  1. Locate the lever lock on the wire dress cover. While pressing the lock, pull the lever over and past the lock until the lever is at the end of its travel.
  2. Disconnect the connector from the component.
  3. Pull the rubber boot that covers the wires back to expose the end of the connector dress cover.
  4. Place the connector locking lever in the center of the connector.
  5. GM1442703

    Locate the 2 dress cover locking tabs that are on the wire end of the connector. Insert a small flat-bladed tool between the cover and connector body and pry up.

  6. GM1442709

    Locate the 2 dress cover locking tabs located on the opposite side of the connector. Insert a small flat-bladed tool between the cover at the connector end and pry up.

  7. Remove the dress cover.
  8. Cut the tie wrap on the wire bundle.
  9. GM1442715

    Remove the terminal position assurance (TPA) by inserting a small flat-bladed tool into the small slot in the end of the slider and pushing on the TPA until it comes out of the connector. When the TPA exits the opposite side of the connector, gasp the TPA and pull it completely out of the connector.

  10. Push the wire side of the terminal that is being removed toward the connector and hold it in position.
  11. GM1442734

    Insert the J-38125-560 into the 2 triangular cavities on each side of the terminal at the front of the connector.

  12. Carefully pull the terminal out of the connector. Always remember never use force when pulling a terminal out of a connector. If the terminal is difficult to remove, repeat the entire procedure.
  13. Repair the terminal by following the Repairing Connector Terminals (Terminated Lead Repair)  procedure.
  14. Insert the repaired terminal back into the cavity. Repeat the diagnostic procedure to verify the repair and reconnect the connector bodies.
scientia non olet · About LEMON Manuals