LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2017 >> Spark LT, Automatic CVT Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 18 (Wiring Systems And Power Management - Diagnostic Information And Procedures) >> Diagnostic Information and Procedures >> Testing for Continuity >> With a Digital Multimeter (DMM)

With a Digital Multimeter (DMM)

WARNING: This page is about a different car, the 2019 Buick Cascada, 2018 Buick Cascada, and 2017 Buick Cascada. However, it is still accessible from the selected car via links, so may be relevant.
  1. Set the DMM to the Ω position.
  2. Disconnect the power feed (i.e. fuse, control module) from the suspect circuit.
  3. Disconnect the load.
  4. Select the MIN MAX function on the DMM.
  5. Connect one lead of the DMM to one end of the circuit to be tested.
  6. Connect the other lead of the DMM to the other end of the circuit.
  7. If the DMM displays low or no resistance, the circuit has good continuity.
scientia non olet · About LEMON Manuals