LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2017 >> Spark LT, Automatic CVT Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 18 (Wiring Systems And Power Management - Diagnostic Information And Procedures) >> Diagnostic Information and Procedures >> Measuring Frequency

Measuring Frequency

WARNING: This page is about a different car, the 2019 Buick Cascada, 2018 Buick Cascada, and 2017 Buick Cascada. However, it is still accessible from the selected car via links, so may be relevant.

Special Tools 

EL - 39200  Digital Multimeter (DMM)

For equivalent regional tools, refer to Special Tools .

CAUTION:

Refer to Test Probe Caution .

The following procedure determines the frequency of a signal.

NOTE:

Connecting the Digital Multimeter (DMM) to the circuit before pressing the Hz button will allow the DMM to autorange to an appropriate range.

  1. Apply power to the circuit.
  2. Set the DMM to the V (AC) position.
  3. Connect the positive lead of the DMM to the circuit to be tested.
  4. Connect the negative lead of the DMM to a good ground.
  5. Set to Hz on the DMM.
  6. The DMM will display the frequency measured.
scientia non olet · About LEMON Manuals