Diagnostic Fault Information
WARNING: This page is about a different car, the 2019 Buick Cascada, 2018 Buick Cascada, and 2017 Buick Cascada. However, it is still accessible from the selected car via links, so may be relevant.
| Circuit |
Short to Ground |
Open/High Resistance |
Short to Voltage |
Signal Performance |
| Left Front Wheel Speed Sensor Ignition |
C0035 06 |
C0035 06 |
C0035 06 |
C0035 0F, C0035 18, C0035 5A |
| Left Front Wheel Speed Sensor Signal |
- |
C0035 06 |
- |
C0035 0F, C0035 18, C0035 5A |
| Right Front Wheel Speed Sensor Ignition |
C0040 06 |
C0040 06 |
C0040 06 |
C0040 0F, C0040 18, C0040 5A |
| Right Front Wheel Speed Sensor Signal |
- |
C0040 06 |
- |
C0040 0F, C0040 18, C0040 5A |
| Left Rear Wheel Speed Sensor Ignition |
C0045 06 |
C0045 06 |
C0045 06 |
C0045 0F, C0045 18, C0045 5A |
| Left Rear Wheel Speed Sensor Signal |
- |
C0045 06 |
- |
C0045 0F, C0045 18, C0045 5A |
| Right Rear Wheel Speed Sensor Ignition |
C0050 06 |
C0050 06 |
C0050 06 |
C0050 0F, C0050 18, C0050 5A |
| Right Rear Wheel Speed Sensor Signal |
- |
C0050 06 |
- |
C0050 0F, C0050 18, C0050 5A |
| Component |
Condition |
DTC Symptom Bytes |
| Wheel Speed Sensor |
- Physical damage
- Debris on the wheel speed sensor or the encoder ring
- Loose or worn wheel bearing
- Loose or improperly mounted sensor
- Air gap between the wheel speed sensor and the encoder ring too large
- Water intrusion in the wiring harness
|
0F, 18 or 5A |