LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2017 >> Spark LT, Automatic CVT Trans >> Repair and Diagnosis >> Body & Frame >> Seats >> Seat Hardware, Seat Trim And Upholstery >> Repair Instructions >> Front Seat Cushion Cover and Pad Replacement

Front Seat Cushion Cover and Pad Replacement

Fig 1: Front Seat Cushion Cover and Pad
GM4025172Courtesy of GENERAL MOTORS COMPANY
Callout Component Name
WARNING: Refer to SIR Warning .

Preliminary Procedures

  1. Remove the driver or passenger seat. Refer to Driver or Passenger Seat Removal and Installation .
  2. Remove the front seat cushion outer trim panel. Refer to Front Seat Cushion Outer Trim Panel Replacement .
  3. Remove the front seat cushion inner trim panel. Refer to Front Seat Cushion Inner Trim Panel Replacement .
1 Front Seat Cushion Cover

Procedure

  1. Disengage the J-channel and hog ring retainers from the seat cushion frame.
  2. Disconnect the electrical connectors that attach to the seat cushion, if equipped.
  3. Remove the seat cushion cover and pad from the seat cushion frame as an assembly.
  4. Separate the seat cushion from the seat cushion pad by pulling the cover away from the pad.
2 Front Seat Cushion Heater
Procedure 
Remove the driver or passenger seat cushion heater, if equipped. Refer to Front Seat Cushion Heater Replacement .
3 Front Seat Cushion Pad
NOTE: The seat belt presence sensor and heat mat, if equipped are integral parts of the seat cushion pad.
scientia non olet · About LEMON Manuals