Circuit/System Verification
- Verify no DTC is set.
- If any DTC is set
Diagnose DTCs first. Refer to Diagnostic Trouble Code (DTC) List - Vehicle .
- If no DTCs are set
- If any DTC is set
- Ignition ON.
- Verify all tachometer segments illuminate and turn off as commanded when performing the Driver Information Center Segments test with the scan tool.
- If tachometer segments do not illuminate
Replace the P16 Instrument Cluster.
- If tachometer segments illuminate properly
- If tachometer segments do not illuminate
- Engine running.
- Verify the tachometer value matches the scan tool Engine Speed parameter.
- If the value does not match
Replace the P16 Instrument Cluster.
- If the tachometer value matches the value displayed on the scan tool
- If the value does not match
- Replace the K20 Engine Control Module.