Fastener Specifications
Single Use Non-Threaded Fasteners/Components
|
NOTE:
All fasteners/components listed in this table MUST BE DISCARDED and replaced with NEW after removal. |
|---|
| Application |
| Inner Constant Velocity Joint Inner Race Circlip |
| Inner Constant Velocity Joint Snap Ring |
| Inner Constant Velocity Joint Outer Race Circlip |
| Inner Joint Boot Large Retaining Clamp |
| Inner Joint Boot Small Retaining Clamp |
| Outer Joint Boot Large Retaining Clamp |
| Outer Joint Boot Small Retaining Clamp |
| Wheel Drive Shaft Washer |
Single Use Threaded Fastener/Component Tightening Specifications
|
NOTE:
All fasteners/components listed in this table MUST BE DISCARDED and replaced with NEW after removal. |
|
|---|---|
| Application | Specification |
| Metric (English) | |
| Wheel Drive Shaft Retaining Nut | |
| First Pass: | 350 N.m (258 lb ft) |
| Second Pass: | Loosen 180 degrees |
| Final Pass: | 370 N.m (273 lb ft) |