LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2017 >> Malibu LS >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 7 (Engine Mechanical - 1.8L (LKN)) >> Repair Instructions - Off Vehicle >> Oil Pump Flow Control Valve Installation

Oil Pump Flow Control Valve Installation

WARNING: This page is about a different variant/trim than selected.
  1. Clean the oil pump flow control valve sealing surface at the engine block.
  2. Install a NEW oil pump flow control valve seal (1).
    Fig 1: Oil Pump Flow Control Valve
    GM3216214Courtesy of GENERAL MOTORS COMPANY
  3. Install the oil pump flow control valve (2).
  4. Install the 3 oil pump flow control valve bolts (3) and tighten to 10 N.m (89 lb in).
    CAUTION: Refer to Fastener Caution .
scientia non olet · About LEMON Manuals