Intake Manifold Installation

WARNING: This page is about a different variant/trim than selected.

Intake Manifold Gasket (2) - Install a NEW gasket.

Fig 1: Intake Manifold
Courtesy of GENERAL MOTORS COMPANY
Intake Manifold (1) - Install
Intake Manifold Bolt - Install [7x]

Fig 2: Intake Manifold Bolt
Courtesy of GENERAL MOTORS COMPANY

NOTE: Simplified graphic: Intake manifold is shown without intake manifold cover absorber.
Intake Manifold Bolt - Tighten in sequence [7x] 25 N.m (18 lb ft)
CAUTION: Fastener Caution
Intake Manifold Brace (1) - Install

Fig 3: Intake Manifold Brace Bolt
Courtesy of GENERAL MOTORS COMPANY
Bolt (2) - Install and tighten [2x] 10 N.m (89 lb in)