LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2017 >> Malibu LS >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 7 (Engine Mechanical - 1.8L (LKN)) >> Repair Instructions - Off Vehicle >> Exhaust Gas Recirculation Cooler Inlet Pipe Removal

Exhaust Gas Recirculation Cooler Inlet Pipe Removal

WARNING: This page is about a different variant/trim than selected.
  1. Remove and DISCARD the engine oil cooler fitting clamp (5).
    Fig 1: Exhaust Gas Recirculation Cooler Inlet Pipe Bolt
    GM4248342Courtesy of GENERAL MOTORS COMPANY
  2. Exhaust Gas Recirculation Cooler Inlet Pipe Bolt (2) - Remove [2x]
  3. Exhaust Gas Recirculation Cooler Inlet Pipe (3) - Remove
  4. Exhaust Gas Recirculation Cooler Inlet Pipe Gasket (1) - Remove and DISCARD
  5. Seal Ring (4) - Remove and DISCARD
  6. Remove and DISCARD the engine oil cooler fitting (1).
    Fig 2: Engine Oil Cooler Fitting
    GM4248343Courtesy of GENERAL MOTORS COMPANY
    NOTE: The engine oil cooler fitting is NOT reusable.
  7. Gasket (2) - Remove and DISCARD
scientia non olet · About LEMON Manuals