Exhaust Gas Recirculation Cooler Inlet Pipe Installation

WARNING: This page is about a different variant/trim than selected.

The clamp (1) from the engine oil cooler fitting (2) is pre-installed.

Fig 1: Turbocharger Coolant Feed Pipe Fitting And Clamp
Courtesy of GENERAL MOTORS COMPANY
Gasket (2) - Install a NEW gasket.

Fig 2: Engine Oil Cooler Fitting
Courtesy of GENERAL MOTORS COMPANY
Install a NEW engine oil cooler fitting (1) and tighten to 24 N.m (18 lb ft).
NOTE: Do NOT remove the engine oil cooler fitting clamp.

CAUTION: Fastener Caution
Seal Ring (4) - Install a NEW seal.

Fig 3: Exhaust Gas Recirculation Cooler Inlet Pipe Bolt
Courtesy of GENERAL MOTORS COMPANY
Clip in the exhaust gas recirculation inlet pipe (3) to the engine oil cooler fitting.
Pull back on pipe to be sure it is seated correctly in the clamp.
Exhaust Gas Recirculation Cooler Inlet Pipe Gasket (1) - Install a NEW gasket.
Exhaust Gas Recirculation Cooler Inlet Pipe Bolt (2) - Install and tighten [2x] 10 N.m (89 lb in)