LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2017 >> Malibu LS >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 7 (Engine Mechanical - 1.8L (LKN)) >> Diagnostic Information and Procedures >> Engine Compression Test >> Measurement Procedure

Measurement Procedure

WARNING: This page is about a different variant/trim than selected.

Check Compression for all cylinders:

  1. Install the EN-51150  compression / pressure adapter (1) into the spark plug hole for the cylinder that is being checked.
    Fig 1: Compression/Pressure Adapter
    GM3216227Courtesy of GENERAL MOTORS COMPANY
  2. Install a compression tester to the EN-51150  compression / pressure adapter.
  3. Start the engine (approx. 4 seconds).
    NOTE: Engine revs at least 300/min.
  4. Compare the compression values.

    Maximum pressure differential 100 kPa (14.5 psi)

  5. Transfer the EN-51150  compression / pressure adapter to the next spark plug hole.
  6. Repeat the process for the remaining cylinders.
scientia non olet · About LEMON Manuals