LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2017 >> Malibu LS >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 7 (Engine Mechanical - 1.8L (LKN)) >> Diagnostic Information and Procedures >> DTC P06DA-P06DC: Engine Oil Pressure Control Solenoid Valve Control Circuit >> Component Testing >> Static Test

Static Test

WARNING: This page is about a different variant/trim than selected.
  1. Ignition OFF, disconnect the harness connector at the Q44 Engine Oil Pressure Control Solenoid Valve.
  2. Test for 10 - 30 Ω between the control terminal 1 and the ignition voltage terminal 2.
    • If not between 10.0-30.0 Ω 

      Replace the Q44 Engine Oil Pressure Control Solenoid Valve.

    • If between 10.0-30.0 Ω 
  3. Test for infinite resistance between each terminal and the Q44 Engine Oil Pressure Control Solenoid Valve housing.
    • If not infinite 

      Replace the Q44 Engine Oil Pressure Control Solenoid Valve.

    • If infinite 
  4. All OK.
scientia non olet · About LEMON Manuals