LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2017 >> Malibu LS >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 5 (Engine Controls And Fuel - 1.8L (LKN) - Repair Instructions) >> Repair Instructions >> Exhaust Gas Recirculation Cooler Temperature Sensor Bracket Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Exhaust Gas Recirculation Cooler Temperature Sensor Bracket (2) - Install
    Fig 1: Exhaust Gas Recirculation Cooler Temperature Sensor Bracket Bolt
    GM4332375Courtesy of GENERAL MOTORS COMPANY
  2. Exhaust Gas Recirculation Cooler Temperature Sensor Bracket Bolt (1) - Install and tighten 10 N.m (89 lb in)
    CAUTION: Refer to Fastener Caution .
  3. Retainer (1) - Install [2x]
    Fig 2: Retainer
    GM4332372Courtesy of GENERAL MOTORS COMPANY
scientia non olet · About LEMON Manuals