Fastener Specifications
WARNING: This page is about a different variant/trim than selected.
Reusable Threaded Fastener Tightening Specifications
|
NOTE:
All fasteners listed in this table can be reused after removal.
|
|
|---|---|
| Application | Specification |
| Metric (English) | |
| Coolant Temperature Sensor | 22.5 N.m (17 lb ft) |
| Coolant Temperature System Control Module Bracket Bolt | 9 N.m (80 lb in) |
| Coolant Temperature System Control Module Bracket Nut | 9 N.m (80 lb in) |
| Drive Motor Battery Cooling Air Inlet Duct Bolt | 2.5 N.m (22 lb in) |
| Drive Motor Battery Cooling Air Outlet Duct Bolt | 2.5 N.m (22 lb in) |
| Drive Motor Battery Cooling Blower Bolt | 9 N.m (80 lb in) |
| Drive Motor Battery Radiator Surge Tank Bolt (Double Studded) | 9 N.m (80 lb in) |
| Drive Motor Battery Cooling Bracket Nut | 5 N.m (44 lb in) |
| Drive Motor Power Inverter Module Coolant Pipe Nut | 9 N.m (80 lb in) |
| Engine Wiring Harness Clip Nut | 9 N.m (80 lb in) |
| Generator Control Module Coolant Pump Bracket Bolt | 9 N.m (80 lb in) |