LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2017 >> Malibu LS >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 3 (Hybrid/EV System Heating And Cooling) >> Repair Instructions >> Drive Motor Generator Power Inverter Module Cooling System Draining and Filling >> Draining Procedure

Draining Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Turn Vehicle Power Off and remove all keyless entry transmitters from the vehicle and secure in a place outside the vehicle.
  2. Place a drain pan under the vehicle.
  3. Remove the drive motor generator control module coolant pump hose (4) from the generator control module coolant pump (5).
    Fig 1: Generator Control Module Coolant Pipe Clip
    GM4322997Courtesy of GENERAL MOTORS COMPANY
  4. Allow the coolant to completely drain from the system.
  5. Install the drive motor generator control module coolant pump hose (4) to the generator control module coolant pump (5).
  6. Remove the drain pan.
scientia non olet · About LEMON Manuals