Removal Procedure

WARNING: This page is about a different variant/trim than selected.

Fold down rear seat back cushion to gain access.
Rear Compartment Side Trim (2) - Remove Rear Compartment Side Trim Replacement - Left Side (Without HP4)Rear Compartment Side Trim Replacement - Left Side (With HP4)

Fig 1: Rear Compartment Side Trim - Left Side (With HP4)
Courtesy of GENERAL MOTORS COMPANY
Drive Motor Battery Cooling Air Outlet Duct Retainer (1) - Remove

Fig 2: Drive Motor Battery Cooling Blower Outlet Duct
Courtesy of GENERAL MOTORS COMPANY
Drive Motor Battery Cooling Air Outlet Duct (2) - Remove
Drive Motor Generator Control Module Tray Retainer (1) - Remove [2x]

Fig 3: Drive Motor Generator Control Module Tray Retainer
Courtesy of GENERAL MOTORS COMPANY
Un-clip the drive motor generator control module tray.
Drive Motor Generator Control Module Tray (2) - Remove
Drive Motor Battery Cooling Bracket Nut (1) - Remove [2x]

Fig 4: Drive Motor Battery Cooling Bracket Nut
Courtesy of GENERAL MOTORS COMPANY
Remove the wiring harness from the upper drive motor battery bracket stud.

Fig 5: Upper Drive Motor Battery Bracket Stud Wiring Harness
Courtesy of GENERAL MOTORS COMPANY
Drive Motor Battery Cooling Bracket Nut (1) - Remove [3x]
Detach the battery cable from the drive motor battery bracket and disconnect the drive motor battery cooling blower electrical connector.
Drive Motor Generator Battery Bracket (1) - Remove

Fig 6: Drive Motor Generator Battery Bracket
Courtesy of GENERAL MOTORS COMPANY
Drive Motor Generator Battery Cooling Air Inlet Duct Retainer (1) - Remove [2x]

Fig 7: Drive Motor Generator Battery Cooling Air Inlet Duct Retainer
Courtesy of GENERAL MOTORS COMPANY
Drive Motor Battery Cooling Blower Inlet Duct (2) - Remove