Conditions for Running the DTC
WARNING: This page is about a different variant/trim than selected.
P16AF
- Ignition Voltage=Greater than 9 V
- Engine Controls Ignition Relay Command=On
DTC runs continuously when the above conditions are met.
P16B3
- DTC P0685 = Not set
- Engine Controls Ignition Relay Command=Off - For greater than 2 s
DTC runs continuously when the above conditions are met.
P16A7
- Engine Controls Ignition Relay Command=On
- Ignition Voltage=Greater than 5.5 V
DTC runs continuously when the above conditions are met.