LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2017 >> Malibu LS >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 29 (Engine Controls And Fuel - 1.8L (LKN) - DTC P0446 To DTC P2635 And Diagnostic Information And Procedures) >> Diagnostic Information and Procedures >> DTC P16A7, P16AF or P16B3: Engine Controls Ignition Relay Feedback Circuit 2 >> Component Testing >> Relay Test

Relay Test

WARNING: This page is about a different variant/trim than selected.
  1. Vehicle Off.
  2. Remove the component: KR75 Engine Controls Ignition Relay
  3. Test for 70 to 110 Ω between the test points: Component terminal 85 & 86
    • If not between 70 and 110 Ω 

      Replace the component: KR75 Engine Controls Ignition Relay

    • If between 70 and 110 Ω 
  4. Test for infinite resistance between the test points:
    • Component terminal 30 & 85
    • Component terminal 30 & 86
    • Component terminal 30 & 87
    • Component terminal 85 & 87
    • If less than infinite resistance 

      Replace the component: KR75 Engine Controls Ignition Relay

    • If infinite resistance 
  5. Connect a 3 A fused jumper wire between the test points: Component terminal 86 & B+

    Connect a jumper wire between the test points: Component terminal 85 & Ground

  6. Test for less than 2 Ω between the test points: Component terminal 30 & 87
    • If 2 Ω or greater 

      Replace the component: KR75 Engine Controls Ignition Relay

    • If less than 2 Ω 
  7. All OK.
scientia non olet · About LEMON Manuals