Circuit/System Verification
WARNING: This page is about a different variant/trim than selected.
WARNING:
Refer to Fuel and Evaporative Emission Pipe Warning
.
CAUTION:
Refer to Clean, Dry, Low Pressure Gas Source Caution
.
- Verify none of the conditions listed below exist:
- Disconnected, incorrectly routed, kinked or damaged EVAP pipes, O-rings and hoses.
- A restricted or plugged EVAP canister.
- If a condition exists
Repair as necessary
- If no conditions exist
- If a condition exists
- Operate the vehicle within the Conditions for Running the DTC. You may also operate the vehicle within the conditions that you observed from the Freeze Frame/Failure Records data.
- If the DTC sets
Refer to Circuit System Testing.
- If the DTC does not set
- If the DTC sets
- All OK.