Circuit/System Description
WARNING: This page is about a different variant/trim than selected.
The EVAP system uses a EVAP leak detection pump to test for system leaks. The EVAP leak detection pump assembly consists of the following components:
- EVAP leak detection pump with reference orifice
- EVAP leak detection pump switching valve
- EVAP leak detection pump pressure sensor
This test determines if there is a restriction between the EVAP System Leak Detection Pump and fuel tank. A restriction will cause the vacuum level, as measured by the EVAP System Leak Detection Pump pressure sensor, to quickly increase beyond a calibration threshold in a short period of time if, there are no other leaks.