Circuit/System Testing
WARNING: This page is about a different variant/trim than selected.
NOTE:
The reference orifice is a small opening at the 2 o'clock position in the pump vacuum opening.
- Vehicle OFF, remove the Q63 Evaporative Emission System Leak Detection Pump Assembly.
- Verify the reference orifice within the pump does not have a restriction.
- If restricted
Inspect and repair any of the conditions listed below:
- The EVAP leak detection pump to the vent solenoid tube and clamps for damage
- A missing or damage EVAP leak detection pump O-rings
- The fresh air tube near the fuel fill pocket for a restriction
- The fresh air tube for a restriction
- If not restricted
Replace the Q63 Evaporative Emission System Leak Detection Pump Assembly.
- If restricted