Circuit/System Verification
WARNING: This page is about a different variant/trim than selected.
- Vehicle in Service Mode.
- Verify that DTCs P145C or P145D is not set.
- If any of the DTCs are set
Refer to Circuit System Testing.
- If no DTCs are set
- If any of the DTCs are set
- Verify that DTCs P2400, P2401 or P2402 is not set.
- If any of the DTCs are set
Refer to Diagnostic Trouble Code (DTC) List - Vehicle .
- If no DTCs are set .
- If any of the DTCs are set
- Operate the vehicle within the Conditions for Running the DTC. You may also operate the vehicle within the conditions that you observed from the Freeze Frame/Failure Records data.
- Verify the DTC does not set.
- If the DTCs set
Refer to Circuit System Testing.
- If the DTC do not set
- If the DTCs set
- All OK.