Circuit/System Verification
WARNING: This page is about a different variant/trim than selected.
- Ignition ON/Vehicle in Service Mode.
- Verify DTC P1426 is not set.
- If DTC P1426 is set
Replace the Q14 Exhaust Gas Recirculation Valve.
- If DTC P1426 is not set
- If DTC P1426 is set
- Operate the vehicle within the Conditions for Running the DTC. You may also operate the vehicle within the conditions that you observed from the Freeze Frame/Failure Records data.
- Verify DTC P1426 does not set.
- If DTC P1426 sets
Replace the Q14 Exhaust Gas Recirculation Valve.
- If the DTC does not set
- If DTC P1426 sets
- All OK.