Relay Test
WARNING: This page is about a different variant/trim than selected.
- Vehicle Off.
- Remove the component: KR75 Engine Controls Ignition Relay
- Test for 70 to 110 Ω between the test points: Component terminal 85 / 2 & 86 / 1
- If not between 70 and 110 Ω
Replace the component: KR75 Engine Controls Ignition Relay
- If between 70 and 110 Ω
- If not between 70 and 110 Ω
- Test for infinite resistance between the test points:
- Component terminal 30 / 5 & 85 / 2
- Component terminal 30 / 5 & 86 / 1
- Component terminal 30 / 5 & 87 / 3
- Component terminal 85 / 2 & 87 / 3
- If less than infinite resistance
Replace the component: KR75 Engine Controls Ignition Relay
- If infinite resistance
- Connect a 3 A fused jumper wire between the test points: Component terminal 86 / 1 & B+
Connect a jumper wire between the test points: Component terminal 85 / 2 & Ground
- Test for less than 2 Ω between the test points: Component terminal 30 / 5 & 87 / 3
- If 2 Ω or greater
Replace the component: KR75 Engine Controls Ignition Relay
- If less than 2 Ω
- If 2 Ω or greater
- All OK.