Circuit/System Verification
WARNING: This page is about a different variant/trim than selected.
- Engine Running.
- Verify that the malfunction indicator lamp turns ON and OFF when commanding the Malfunction Indicator Lamp (MIL) On and Off with a scan tool.
- If the malfunction indicator lamp does not turn ON and OFF
Refer to Circuit/System Testing.
- If the malfunction indicator lamp turns ON and OFF
- If the malfunction indicator lamp does not turn ON and OFF
- Operate the vehicle within the conditions for running the DTC. You may also operate the vehicle within the conditions you observed from the Freeze Frame/Failure Records data.
- If the DTC sets
Refer to Circuit/System Testing.
- If the DTC does not set
- If the DTC sets
- All OK.