Circuit/System Verification
WARNING: This page is about a different variant/trim than selected.
WARNING:
Refer to Fuel and Evaporative Emission Pipe Warning
.
CAUTION:
Refer to Clean, Dry, Low Pressure Gas Source Caution
.
- Verify the following conditions do not exist in the EVAP system:
- Loose or damaged capless fuel fill
- A damaged EVAP purge solenoid
- Disconnected, incorrectly routed, kinked or damaged EVAP pipes and hoses
- A damaged EVAP canister
- If you find any of the above conditions
Repair as necessary
- If none of the above are found
- If you find any of the above conditions
- Operate the vehicle within the Conditions for Running the DTC. You may also operate the vehicle within the conditions that you observed from the Freeze Frame/Failure Records data.
- Verify the DTC does not set.
- If the DTC sets
Refer to Circuit/System Testing.
- If the DTC does not set
- If the DTC sets
- All OK.